LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2005 >> DeVille Protection Series >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Identifying Sensor & Retaining Bolt
    GM11835Courtesy of GENERAL MOTORS CORP.
  1. Install the vehicle speed sensor (130) and the retaining bolt (131). Install a new O-ring seal on sensor if necessary.

    Tighten:  Tighten the bolt to 10 N.m (89 lb. in.).

  2. Install the electrical connector at the sensor.
    3. Fig 2: Mounting Bolt Locations For Front Transaxle Brace
    GM588753Courtesy of GENERAL MOTORS CORP.
  3. Install the bolts (1, 3) securing the front transaxle brace (2) to the transaxle and right cylinder head.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals