LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2003 >> Seville SLS >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Lighting Systems (Introduction)) >> Repair Instructions >> Backup Lamp Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Expanded View of Backup Lamp Connector & Fasteners
    GM105154Courtesy of GENERAL MOTORS CORP.
  1. Route the backup lamp connector (5) and the grommet (3) through the rear compartment lid (2).
  2. Install the backup lamp (1) to the rear compartment lid (2).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the fasteners (1) in order to secure the backup lamp (1) to the rear compartment lid (2).

    Tighten:  Tighten the fasteners to 4.5 N.m (40 lb in).

  4. Verify that the grommet (3) is fully seated in the rear compartment lid (2).
  5. Connect the backup lamp connector (5) to the rear compartment lid wiring harness.
  6. Install the rear compartment lid trim. Refer to Compartment Lid Trim Replacement - Rear in Body Rear End.
  7. Close the rear compartment lid.
scientia non olet · About LEMON Manuals