Removal Procedure
- Remove the IP top trim panel. Refer to TRIM PANEL REPLACEMENT - INSTRUMENT PANEL (IP) UPPER .
- Remove the drivers side accessory housing (1) from the IP.
- Remove the transfer case control module, if equipped. Refer to TRANSFER CASE SHIFT CONTROL MODULE REPLACEMENT .
- Release the pressure on the headliner wire harness by removing the wire harness retainer (1) from the IP support beam.
- Disconnect the headliner wire connectors from the junction block located next to the brake pedal.
- Remove the wire harness retainers along the windshield pillar.
- Follow the routing of the wire harness through the IP and release any wire harness retainers.
- Carefully pull out the wire harness from the windshield pillar ensuring that the wire harness does not get caught on any part.
- Remove the center trim pillar moldings. Refer to Garnish Molding Replacement - Center Pillar .
- Remove the third pillar trim pillar moldings. Refer to Trim Replacement - Third Pillar (Tahoe/Yukon/Escalade/Suburban) or Trim Replacement - Third Pillar (Avalanche/Escalade EXT) .
- Remove the rear corner trim pillar moldings. Refer to Garnish Molding Replacement - Rear Corner .
- Disconnect the electrical connector to the rear view mirror.
- Remove the upper console. Refer to Console Replacement - Overhead (Full Length) or Console Replacement - Overhead (Short Length) .
- Remove the front sunshades. Refer to Sunshade Replacement .
- Remove the sunshade holders.
- Remove the rear coat hook, if equipped. Refer to Coat Hook Replacement .
- Remove the assist handles. Refer to Assist Handle Replacement - Rear .
- Remove auxiliary climate control console assembly. Refer to HVAC CONTROL ASSEMBLY .
- Remove the roof mounted air outlet louver by turning counter clockwise in order to remove the retainer.
- Remove the retainer.
- Remove the sunroof finishing lace, if equipped. Refer to SUNROOF FINISHING LACE REPLACEMENT .
- Remove the rear headliner retainers, if needed.
- Carefully separate the air duct at the right C-pillar from the headliner.
- Carefully separate the headliner from the roof Velcro(R) retainers.
- With the aid of an assistant carefully slide the headliner out through the rear of the vehicle.
- Remove the interior dome lamp assembly in order to transfer to the new headliner. Refer to DOME LAMP REPLACEMENT .