Window Regulator: Removal
- Remove door trim panel. See DOOR TRIM PANEL . Remove appropriate door module. See DOOR MODULES . Remove water deflector.
- Remove inside handle assembly (4) to gain access to window clamp attachment bolts:
- Disconnect handle rod (3) from clip guide (2). See Figure .
- Connect power window switch and door module. Raise window to full up position. Tape window in place.
- Loosen window clamp attachment fasteners. Lower regulator clamps (2) to full down position. See Figure .
- Disconnect electrical connector from window regulator motor.
- Remove window regulator to inner door panel fasteners (2, 3). Remove window regulator (1) from inner door panel. See Figure .