Cruise Control Release Switch: Installation
WARNING: This page is about a different car, the 2000 Cadillac Catera. However, it is still accessible from the selected car via links, so may be relevant.
- Pull locking sleeve outward about 2/3" in order to fully extend actuating pin. Connect cruise control release switch harness connector.
- Apply and hold brake pedal. Insert cruise control release switch into bracket until switch lugs snap securely in place. Release brake pedal and allow it to rise to non-applied position. This will adjust actuator pin to proper position. Press locking sleeve into switch body. Install floor outlet duct and insulator panel.