LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2023 >> Envision Preferred, AWD >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Electronic Transmission Range Select >> Diagnostic Information and Procedures >> DTC P17E0 or P17E1 >> Circuit/System Testing
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Circuit/System Testing

NOTE:

Some control module ground circuits may require up to 20 min after the ignition is turned off before achieving a resistance reading of less than 5 Ω. In most cases the readings will drop below 20 Ω within 1 min indicating the control module is going to sleep.

  1. Ignition OFF and all vehicle systems OFF, disconnect the harness connectors at the K212 Gear Shift Control Module. It may take up to 2 min for all vehicle systems to power down.
  2. Verify a test lamp illuminates between ground circuit terminal 20 and B+.
    • If the test lamp does not illuminate 

      Repair the open/high resistance on circuit 1850 or the ground connection.

    • Go to next step: If the test lamp illuminates 
  3. Verify a test lamp illuminates between B+ circuit terminal 9 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Test circuit 7040 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open/high resistance is not found.
    2. Replace the X51A Fuse Block - Instrument Panel for an internal fault.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Test circuit 7040 for a short to ground.
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found.
    2. Replace K212 Gear Shift Control Module.
    • Go to next step: If the test lamp illuminates 
  4. Ignition ON.
  5. Verify a test lamp illuminates between ignition circuit terminal 17 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Test circuit 1239 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open/high resistance is not found.
    2. Replace the X51A Fuse Block - Instrument Panel for an internal fault.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Test circuit 1239 for a short to ground.
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found.
    2. Replace K212 Gear Shift Control Module.
    • Go to next step: If the test lamp illuminates 
  6. Replace the K212 Gear Shift Control Module.
scientia non olet · About LEMON Manuals