LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2020 >> Envision Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 172 (Power Steering System) >> Diagnostic Information and Procedures >> DTC C1436 >> Circuit/System Verification
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Verification

WARNING: This page is about a different car, the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition = On
  2. Verify there are no DTCs set related to the following component/system: K43 Power Steering Control Module
    • Go to next step: If a related DTC is not set 
    1. Verify DTC U0126, U0130, U0131 is not set.
      • Go to next step: If a DTC was not set 
    2. Verify DTC C0035-C0050 is not set. - Electronic Brake Control Module
      • Go to next step: If a DTC was not set 
  3. Perform the following procedure/test: Steering Wheel Angle Sensor Centering
    • If the repair corrected the DTC/symptom 

      All OK.

    • Go to next step: If the repair did not correct the DTC/symptom 
  4. Replace the component: Steering Gear
    • If the repair corrected the DTC/symptom 

      All OK.

    • Go to next step: If the repair did not correct the DTC/symptom 
  5. Replace the component: K17 Electronic Brake Control Module
  6. All OK.