LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2020 >> Envision Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Sunroof System) >> Diagnostic Information and Procedures >> DTC B3664 >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

WARNING: This page is about a different car, the 2018 Buick Regal TourX and 2018 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    It may take up to 2 min for all vehicle systems to power down before an accurate ground or low reference circuit continuity test can be performed.

  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector: A98 Front Overhead Console Assembly
  3. Test for less than 10 ohms between the test points: Low Reference circuit terminal 20 @ Component harness & Ground
    • If 10 ohms or greater 
    1. Disconnect the appropriate electrical connector: K61 Sunroof Control Module
    2. Test for less than 2 ohms between the test points: Low Reference circuit terminal 20 @ Component harness & The other end of the circuit
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Test or replace the component: K61 Sunroof Control Module
    • Go to next step: If less than 10 ohms 
  4. Ignition - On/Vehicle - In Service Mode
  5. Test for 4.5 to 5.5 V between the test points: Signal circuit terminal 9 @ Component harness & Ground
    • If less than 4.5 V 
    1. Ignition/Vehicle - Off
    2. Disconnect the appropriate electrical connector: K61 Sunroof Control Module
    3. Test for infinite resistance between the test points: Signal circuit terminal 9 @ Component harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • Go to next step: If infinite resistance
    4. Test for less than 2 ohms between the test points: Signal circuit terminal 9 @ Component harness & The other end of the circuit
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component: K61 Sunroof Control Module
    • If greater than 5.5 V 
    1. Ignition/Vehicle & All vehicle systems - Off
    2. Disconnect the appropriate electrical connector: K61 Sunroof Control Module
    3. Test for less than 1 V between the test points: Signal circuit terminal 9 @ Component harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • If less than 1 V - Replace the component: K61 Sunroof Control Module
    • Go to next step: If between 4.5 and 5.5 V 
  6. Test or replace the component: A98 Front Overhead Console Assembly
scientia non olet · About LEMON Manuals