Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Outer Disc Brake Pad (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Inner Disc Brake Pad (1) - Install
Position the brake caliper to the brake caliper bracket.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Brake Caliper Guide Pin Bolt (1) - Install [2x] 25 N.m (18 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Caliper Guide Pin Seal (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Brake Caliper Spring (1) - Install
Install the tire and wheel assembly. Tire and Wheel Removal and Installation
With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
Slowly release the brake pedal.
Wait 15 seconds, then repeat steps 8-9 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
Fill the brake master cylinder reservoir to the maximum-full level with GM approved brake fluid from a clean, sealed brake fluid container. Brake Master Cylinder Reservoir Filling
Calibrate the park brake. Park Brake Calibration
Burnish the brake pads and rotors. Brake Pad and Rotor Burnishing