Remove & Install or Remove & Replace
WARNING: This page is about the Encore Base, AWD, which is a different variant/trim than selected.
TRANSAXLE TYPE
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Front Axle,Both | 2.2 | B | ||
| Front Axle,One Side | 1.2 | B | ||
| Front Axle,One Side | 1.2 | 0.7 | B | |
| Combination Procedure: AXLE SHAFT: Replace: NOTE: For Independent Suspension Type Axles, this operation consists of dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft. | ||||
| Front Axle,Each | 0.5 | B | ||
| Combination Procedure: AXLE SHAFT BOOT: Remove & Replace: | ||||
| Front Axle,Inner &/or Outer,Each Side | 0.5 | B | ||
| Combination Procedure: AXLE SHAFT JOINT: Remove & Replace: | ||||
| Front Axle,Each | 0.4 | B | ||
| Combination Procedure: TRANSAXLE OUTPUT SEAL: Remove & Replace: | ||||
| AWD, Front Axle,Left Side | 0.2 | B | ||