Circuit/System Verification
WARNING: This page is about a different car, the 2013 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- Check the cooling system for the correct amount of coolant. Refer to Cooling System Draining and Filling (Static Fill) , Cooling System Draining and Filling (GE 47716) .
- Verify that DTC P0A2C is not set.
- If DTC P0A2C is set, Refer to DTC P0A2B-P0A2D .
- Ignition ON, observe the scan tool motor temperature parameter. The reading should be less than 165°C (329°F). If greater than the specified value, replace the starter generator assembly.