LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2005 >> Rendezvous Ultra, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.6L - Introduction >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

  1. Install the MAF sensor seal to the air cleaner cover.
    2. Fig 1: Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
    GM1395972Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do NOT use any lubricant other than clean water on the MAF seal.
  2. Lubricate the seal with clean water.
  3. Install the MAF sensor to the air cleaner cover.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the MAF sensor screws.

    Tighten:  Tighten the MAF sensor screws to 4 N.m (35 lb in).

  5. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
  6. Install the MAF sensor electrical connector.
scientia non olet · About LEMON Manuals