LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2005 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Torque Converter Clutch/Cruise Control Release Switch Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: Identifying Brake Pedal & Stop Lamp Switch
    GM575743Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When installing the torque converter clutch/cruise control release switch, ensure that the brake pedal remains in the full up or at rest position.
  1. Connect the upper switch (1) electrical connector.
  2. Install the upper switch (1) into the upper retainer.
  3. Rotate the switch clockwise until fully seated.
  4. Adjust the switch. Refer to Torque Converter Clutch/Cruise Control Release Switch Adjustment .
  5. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals