Keyless Entry Module: Service and Repair

Programming Keyless Entry Module/Transmitter(s)
One (1) or two (2) transmitters may be programmed. When two (2) transmitters are to be programmed, they must be programmed during the same program sequence (see procedure).

1. Connect a fused jumper to the Keyless Programming Connector from terminal "A" to terminal "B". The Keyless Entry Module will cycle all the Door Lock Motors once.

2. Press any button on the transmitter once. In response, the Keyless Entry Module will cycle all the Door Lock Motors once.

3 If a second transmitter is to be programmed, press any button on the second transmitter once. In response, the Keyless Entry Module will cycle all the Door Lock Motors once

4. Remove the fused jumper from the Keyless Programming Connector