October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

41 00... Stamping Vehicle Identification Number

Special tools required:

NOTE: If the stamped vehicle identification number is removed during repair work, it must be stamped in again.
Read and comply with GENERAL NOTES .

Necessary preliminary tasks:

Remove FRONT RIGHT SPRING STRUT .
Remove rubber base from guide plate 41 1 141 .

The set of special tools 41 1 140 for stamping the vehicle identification number consists of:

Guide plate 41 1 141 .

Counter-support plate 41 1 142 .

Fig 1: Identifying Guide Plate (41 1 141) And Counter-Support Plate (41 1 142)

G09861109

Courtesy of BMW OF NORTH AMERICA, INC.

Position counter-support plate 41 1 142 at bottom on spring strut dome.

Position guide plate 41 1 141 at top on spring strut dome and tighten screws (1) by hand.

Fig 2: Positioning Counter-Support Plate (41 1 142)

G09861110

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screw (1) until counter support 41 1 142 rests on spring strut dome.

Fig 3: Identifying Counter Support (41 1 142)

G09861111

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Fig 4: Positioning Counter-Support Plate (41 1 142)

G09861112

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The illustration is a schematic diagram and is to be applied to the relevant vehicle type.

Insert punch numbers 41 0 000 (1) individually into guide plate (2) and stamp vehicle identification number.

Fig 5: Inserting Punch Into Guide Plate

G09861113

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: In the event of component or body replacement by the workshops/garages, clearly delimit the vehicle identification number at front and rear by stamping a "+" in place of the BMW emblem.
Note national regulations.