System functions

The following BMW Night Vision system functions are described:

• Power supply and ground
• Heating for protective glass on the night-vision camera
• Cleaning the protective glass on the night-vision camera
• Zoom function
• Panning image section
• Function limitations

  Power supply and ground 

  • E60, E61, E63, E64

  The rear power distributor supplies the night-vision electronics with terminal 30g.

  • E65, E66

  The front power distributor supplies the night-vision electronics with terminal 30.

  The night-vision camera, including the heating, receives its power from the night-vision electronics.

  The night-vision electronics and the night-vision camera share a common ground point. This reduces the system's susceptibility to malfunctions.

  Heating for protective glass on the night-vision camera 

  To prevent the protective glass from misting or freezing over, a heating element is installed in the housing of the night-vision camera. The heating is switched on under the following conditions:

  • Ambient temperature between 5 °C and -15 °C

  Cleaning the protective glass on the night-vision camera 

  The night-vision camera is equipped with a cleaning system.

  The washer jet is bolted to the night-vision camera with a bracket. The washer jet is connected to the headlamp cleaning system. The cleaning of the protective glass is actuated together with the headlamp cleaning system.

  Zoom function 

  The zoom function can be selected as needed. To do this, select "Zoom" in the BMW Night Vision menu.

  The zoom is calculated by the night-vision camera. The zoom function can only be selected when the "Full image" display is not selected.

  When zoom is active, the display is automatically enlarged 1.5 -fold at speeds of 70 km/h upwards. Here, the viewing angle of the night-vision camera is reduced from 36° to 24°.

  Zoom is automatically deactivated when the vehicle's speed drops below 60 km/h. The viewing angle of the night-vision camera is restored to 36°.

  (zoom IN over 70 km/h and zoom OUT under 60 km/h: currently only encoded for Europe version)

  Panning image section 

  The image section can be panned when "Cornering mode" is selected in the BMW Night Vision menu. "Cornering mode" is only executed when zoom is activated.

  The image section then follows the vehicle's path through a bend (signals: steering angle, yaw rate).

  The night-vision camera calculates the panning angle needed for the image section.

  "Cornering mode" can only be selected when the "Full screen" display is not  selected.

  Function limitations 

  On vehicles with rear entertainment system (rear display): 

  It is not possible to run the following simultaneously:

  • BMW Night Vision in the front
  • and navigation or BMW Assist in the rear

  If navigation or BMW Assist is selected on the rear display: BMW Night Vision is switched off on the Control Display in the front.

  When BMW Night Vision is switched back on again, an appropriate message appears on the rear display.

Preconditions for activation 

BMW Night Vision is operational from terminal R.

Press the BMW Night Vision button.

BMW Night Vision will switch on in the following conditions:

• The rain-light sensor detects sufficient ambient light. Driving lights are off:

  BMW Night Vision is operational 2 seconds after the button is pressed. At the earliest 30 seconds after the vehicle is activated (navigation system booted). During these 2 seconds, a warning appears on the Control Display or Central Information Display.

• The rain-light sensor detects insufficient ambient light. Driving lights are on:

  BMW Night Vision is operational immediately after the button is pressed.

• The rain-light sensor detects insufficient ambient light. Driving lights are off. Road speed is less than 5 km/h (e.g. in dark driveways or garage entrances):

  BMW Night Vision is operational immediately after the button is pressed.

BMW Night Vision is not  switched on in the following conditions:

• The rain-light sensor detects insufficient ambient light. Driving lights are off. Road speed greater than 5 km/h at the same time.

A corresponding warning appears on the Control Display or Central Information Display.

Subject to change.