61 00... Notes On Handling Optical Fibers
CAUTION:
To avoid damage when handling optical fibers, comply with the following points:
- The minimum permitted bending radius is 25 mm.
- Do not subject optical fibers to compressive and tensile load.
- Protect optical fibers against the effects of heat "GREATER THAN EQUALS TO" 85° C (e.g. during welding work, drying work with infrared heater or hot air blower).
- Optical fibers are permitted to show only one junction point (bridge), replace optical fibers if necessary.
NOTE:
The optical fibers are colored differently as follows:
- Green =MOST (M edia O riented S ystems T ransport) optical fibers.
- Yellow =ISIS (I ntelligent S afety and I ntegration S ystem) optical fibers.
- Orange = repair optical fibers.
Follow instructions for Treating cables and fibre-optic cables