Specifications Index
X5 SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | HEATING AND AIR CONDITIONING - TECHNICAL DATA - X5 (4.4L) | |
| Torque | HEATING AND AIR CONDITIONING - TIGHTENING TORQUES | |
| Axle Nut/Hub Nut | ||
| Front & Rear | 310 Ft. Lbs. (420 N.m) | |
| Brakes | ||
| Bleeding Sequence | BLEEDING PROCEDURES | |
| Disc Brakes | BRAKE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | GENERATOR SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | ADJUSTMENTS | |
| Belt Routing | DRIVE BELT ROUTING | |
| Engine Cooling | ||
| General Service Specifications | SPECIFICATIONS | |
| Radiator Cap Pressure | 21.75 psi (150 kPa) Pressure is approximate and may vary slightly by vehicle. See cap top for specification. |
|
| Thermostat R & I | REMOVING AND INSTALLING / REPLACING COOLANT THERMOSTAT (M62) | |
| Water Pump R & I | REMOVING AND INSTALLING/REPLACING WATER PUMP (M62 / S62) | |
| Engine Mechanical | ||
| Compression | CHECKING COMPRESSION OF ALL CYLINDERS (M60 / M62 / M73 / S62 / M54) | |
| Oil pressure | Oil pressure should be more than 7.2 psi (49 kPa) at idle; regulated pressure and 65 psi (448 kPa) at 6500 RPM. | |
| Overhaul | ENGINE - TECHNICAL DATA - X5 (4.4L) | |
| Torque | ENGINE - TIGHTENING TORQUES - X5 (4.4L) | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or Maint." button. | |
| Flywheel/Flex Plate Torque | FLYWHEEL | |
| Fuel System | ||
| Fuel Filter Location | Under vehicle, forward from fuel tank along fuel feed line behind fuel filter cover. | |
| Fuel Filter R & I | REPLACING FUEL FILTER (M62, M54) | |
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | |
| Pressure Specification | 50 psi (344 kPa) | |
| Fuel Pressure Test Procedure | CHECKING DELIVERY PRESSURE OF FUEL PUMP (M62) | |
| Ignition | ||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER INDENTIFICATION | |
| Ignition Wires (Routing) | Coil on plug | |
| Spark Plug | ||
| Type | Bosch F8 LDCR | |
| Gap | Spark plug gap is not adjustable. | |
| Torque | 23 Ft. Lbs. (31 N.m) | |
| Starting | ||
| Starter | STARTER SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment Specifications | ALIGNMENT SPECIFICATIONS - E53 | |
| Torque | TORQUE SPECIFICATIONS - E53 | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 96-111 Ft. Lbs. (130-150 N.m) | |