LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> BMW >> 1989 >> 635CSi Standard >> Repair and Diagnosis >> Steering >> Steering Column >> Removal & Installation >> Driver-Side Air Bag Module >> Removal & Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal & Installation

  1. Before proceeding further, follow the air bag service precautions. Refer to SERVICE PRECAUTIONS  . Disable the SRS. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM  .
  2. Using Torx TX30 bit with long shank, remove Torx screws from rear of steering wheel. Lift off air bag module enough to unplug wiring connector from rear of module. Place module away from work area (in trunk), with pad facing upward.
  3. To install, reverse removal procedure. Tighten Torx screws to 70 INCH lbs. (8 N.m). Activate SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM  . Perform system operation check to ensure system is functioning properly. See SYSTEM OPERATION CHECK  .
scientia non olet · About LEMON Manuals