Night Vision System Control Module -J853-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S6, 2022 Audi A6 Quattro, 2021 Audi S6, 2021 Audi A6 Quattro, and 2020 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Loosen the left front seat and, with the wires still attached, push it toward the rear. Refer to OVERVIEW - FRONT SEAT .

-- Remove the floor mat.

-- Remove the sill panel. Refer to SILL PANEL, REMOVING AND INSTALLING .

-- Remove the footrest. Refer to FOOTREST, REMOVING AND INSTALLING .

-- Disengage the carpet and push it aside.

-- Remove the nuts -arrows- from the bracket -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connectors -3- from the Night Vision System Control Module -J853- -1-.

-- Remove the Night Vision System Control Module -J853- -1- with the bracket -2-.

-- Remove the bolts -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Night Vision System Control Module -J853- -1- from the bracket -2-.