Laser Distance Regulation Control Module -J1122-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi SQ8, 2022 Audi RS Q8, 2022 Audi Q8, 2021 Audi SQ8, and 2021 Audi RS Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Remove the upper air guide. Refer to OVERVIEW - RADIATOR/RADIATOR FAN .

-- Release the clamp on the washer fluid hose connecting piece -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the washer fluid hose from the washer nozzle -2-.

-- Remove the washer nozzle -2- on the cap -3- all the way forward from the radiator grille and hold it in this position.

-- Push the retaining tabs on the cap -3- apart in direction of -A arrows-.

-- Remove the cap -3- from the washer nozzle -2- in direction of -arrow B-

-- Clean and dry the Laser Distance Regulation Control Module -J1122- -2- near the connector -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connector -2-.

-- Remove the wiring harness bracket -1- from the Laser Distance Regulation Control Module -J1122- -2-.

-- Remove the screws -arrows-.

-- Remove the Laser Distance Regulation Control Module -J1122- -2- toward the rear from the radiator grille.