Driver Assistance Systems Front Camera, Calibrating, Dynamic Calibration (Calibration Drive)

Calibrating the front camera is necessary:

• The installation position of the Driver Assistance Systems Front Camera -R242- in the vehicle has changed.
• Rear axle toe/chamber was adjusted.

Special tools and workshop equipment required 

• Vehicle Diagnostic Tester

Calibration Conditions

• DTC memory is without relevant entry.

Procedure 

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic  operating mode.

-- Select the Test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

• Diagnostic-capable systems
• 00A5 - Driver Assistance Systems Front Camera - R242
• 00A5 - Driver Assistance Systems Front Camera - R242, Functions
• 00A5 - Calibration

-- Start the selected program and follow the instructions on the display of the Vehicle Diagnostic Tester by running a short calibration run.

Dynamic calibration of several driver assistance systems.

The front camera and the other driver assistance systems can alternatively be calibrated together during the calibration run, to do so, select the following tree structure:

• Diagnostic-capable systems
• 00A5 - Driver Assistance Systems Front Camera - R242
• 00A5 - Driver Assistance Systems Front Camera - R242, Functions
• 00A5 - Dynamic Calibration of several Driver Assistance Systems

-- Start the selected program and follow the instructions on the display of the Vehicle Diagnostic Tester by running a short calibration run.