DTC Memory, Checking

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5, 2022 Audi RS 5, 2022 Audi A5 Quattro, 2021 Audi S5, and 2021 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Set v and press Accept to select "Work with Guided Fault Finding".

The control module identification and checking the DTC memory occurs next. Observe the instructions and test conditions.

-- Switch to the "Control modules" tab and open the "DTC memory list" to view all of the stored DTC memory entries.

-- Change to the "test plan" tab and perform the specified test programs.