14.3 Night Vision System Control Module, Removing And Installing

Special Tools And Workshop Equipment Required

Removing

The Night Vision System Control Module - J853- is located in the front left footwell.

NOTE: If replacing the control module, select the "Replace Control Module" function see Vehicle Diagnostic Tester.

Loosen the front left seat and with the wires still attached and push rearward. Refer to Body Interior (Front Seats; Overview - Front Seat).
Remove the floor mat.
Remove the sill panel. Refer to Body Interior (Passenger Compartment Trim; Overview - Sill Panel Strip).
Remove the foot rest. Refer to Body Interior (Passenger Compartment Trim; Overview - Foot Rest and Carpet).
Remove the cover -1- for the emergency release in direction of -arrows-.
Disengage the carpet and push aside, while doing this guide the cover -1- for the emergency release through the opening.
Release the clips in the direction of the -arrows-.
Open cover -1-.
Release connectors -1 and 2- and remove from the Night Vision System Control Module - J853- -3-

First release connector -2- and then
- Push the retaining tab in the direction of the -arrow- and remove the Night Vision System Control Module - 853- -3- from the E-box.

Installing

Install in reverse order.