October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Clip on Distance Regulation Control Module -J428-/Distance Regulation Control Module 2 -J850-, Replacing: Procedure
- Remove the distance regulation control module retaining plate. Refer to Retaining Plate for Distance Regulation Control Modules -J428-/-J850-, Removing and Installing
.
NOTE:
- If the stud bolts were removed, then the clips on the distance regulation control module must be replaced.
- The clips cannot be removed without being damaged.
- Remove the stud bolt -1- using a suitable tool -2- in direction of -arrow-.
 Courtesy of AUDI OF AMERICA, LLC
|
- Place a screwdriver between the hook and the housing -A-.
- Bend every hook all the way around with the screwdriver until it audibly breaks off -B-.
- To prevent the broken hook from getting caught on the housing, remove it from the inside of the clip using needle nose pliers in direction of -arrow-.
 Courtesy of AUDI OF AMERICA, LLC
|
- Insert the new clip into the hole in the housing in direction of -arrow- from the left and then press on it by hand until it clicks into place -A-.
- The tabs on the clip must sit correctly in the recesses -B-.
- Install the stud bolt.
- The stud bolt must be parallel inside the hole in direction of -arrow- and correctly aligned to the clip.
 Courtesy of AUDI OF AMERICA, LLC
|
- Turn the stud bolt into the distance regulation control module up to the dimension -a-.
- Repeat this procedure on all the other clips, if necessary.
 Courtesy of AUDI OF AMERICA, LLC
|