Distance Regulation Control Module - J428- / Distance Regulation Control Module 2 - J850- Retaining Plate, Removing and Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the quick release
The stud bolts in the bracket are pre-set. If necessary, correct the setting.
If the stud bolts were removed, then the clips on the distance regulation control module must be replaced. Refer to DISTANCE REGULATION CONTROL MODULE - J428- / DISTANCE REGULATION CONTROL MODULE 2 - J850- CLIP, REPLACING .

Place the control module on a soft and clean surface.
Measure the dimension -a- at all stud bolts using the Digital Caliper - VAS 6335- and correct if necessary.

The dimension -a- = 43.3 mm.

Fig 1: Identifying Stud Bolt Dimension -a-

Courtesy of AUDI OF AMERICA, LLC

Position the retaining plate -2- onto the distance regulation control module -item 3-.
Carefully press the new quick release -4- onto the stud bolt -2-.
Turn the quick release clockwise onto the retaining plate to the stop.

Fig 2: Identifying Distance Regulation Control Module Retaining Plate And Quick Releases

Courtesy of AUDI OF AMERICA, LLC