Accelerator Pedal Module, Version 1

Special tools and workshop equipment required

Removing

-- Remove cover for steering column -arrows-.

Fig 1: Identifying Steering Column Cover

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect electrical harness connector -2-, by pressing release button to the stop -arrow-.

Fig 2: Component Location Of Throttle Position (TP) Sensor G79 With Accelerator Pedal Position Sensor 2 G185

Courtesy of AUDI OF AMERICA, LLC

-- Where necessary, pull the wiring router -1- off from the accelerator pedal module.

-- Pry off the cover using a screwdriver.

-- Remove the bolt.

-- Push the T10238 into the intended openings -arrow- as far as the stop, as shown, and remove the accelerator pedal module.

Fig 3: Identifying Release Tool T10238

Courtesy of AUDI OF AMERICA, LLC

Installing

Install in reverse order, paying attention to the following:

-- Connect the wiring router -1- and the electrical connector -2- to the accelerator pedal module -5-.

Fig 4: Connecting Wiring And Electrical Harness Connector To Accelerator Pedal Module

Courtesy of AUDI OF AMERICA, LLC

-- Push the accelerator pedal module onto the securing studs -6-.

-- Insert centering pin -7- into hole on the underbody.

-- Secure the accelerator pedal module with the bolt -3- and install the cap -4-.

Vehicles with Dual Clutch Transmission:

-- Perform after the first kick-down adaptation in "Guided Functions" using the vehicle diagnostic tester.