Upper Intake Manifold Overview
- Vacuum Hose
- Intake Manifold Tuning (IMT) Valve -N156-
- Bolt
- 2.5 Nm
- For Intake Manifold Tuning (IMT) Valve Position Sensor -G513-
- Bolt
- 2.5 Nm
- Actuator for Intake Manifold Change-Over
- Installed location of tooth segments for variable intake manifold, refer to Fig 2
- As replacement part together with -26-
- Seal
- Replace if damaged
- Lift out with screwdriver to replace
- Press in by hand
- Ball Pin
- 2.5 Nm
- Upper Intake Manifold
- Removing and installing, refer to UPPER INTAKE MANIFOLD
- Seal
- Replace
- Throttle Valve Control Module -J338-
- Bracket
- Bolt
- 6 Nm
- Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-
- Hose
- Bolt
- 3 Nm
- Intake Air Temperature (IAT) Sensor -G42- /Manifold Absolute Pressure (MAP) Sensor -G71-
- O-ring
- Replace
- Bolt
- 2.5 Nm
- Hose for Crankcase Ventilation
- O-ring
- Replace
- Bolt
- 8 Nm
- Washer
- Sleeve
- Seals
- Replace
- Seal
- Replace if damaged
- Lift out with screwdriver to replace
- Press in by hand
- Lever with Tooth Segment
- For variable intake manifold
- Installed location of tooth segments, refer to Fig 2
- As replacement part together with -5-
- Seal
- Replace if damaged
- Lift out with screwdriver to replace
- Press in by hand
- Vacuum Hose
- The lower edges of the toothed segments must align with one another -arrow-.