Ignition Key Lock, Checking

WARNING: This page is about a different variant/trim than selected.

-- To reach "ignition on", turn the key to right.

-- Press the brake pedal and hold it down.

It must be possible to move the selector lever out of "P" without "getting stuck" when the locking button in the selector lever handle is pressed.

-- Turn off the ignition.

It should not be possible to remove the ignition key when the selector lever is in any other position than "P".

-- Move the selector lever into "P".

-- Remove ignition key.

It should be possible to remove the key only when the selector lever is in "P".
It is not possible to move the selector lever out of "P" when both the locking button and the brake pedal are pressed.

NOTE:

Check the Access/Start Authorization Switch -E415- in Guided Fault Finding if the key lock does not work as described. Refer to Vehicle Diagnostic Tester.