Automatic Glow Time Control Module -J179-

WARNING: This page is about a different car, the 2013 Audi A3, 2012 Audi A3, 2011 Audi A3, and 2010 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Turn the ignition and remove the ignition key.

-- Remove cover -1- from above battery, by pressing the release button -arrow-.

Fig 1: Identifying Cover Over Battery Removed By Pressing Release Button

Courtesy of AUDI OF AMERICA, LLC

-- Remove the battery. Refer to [For engine(s) CBRA, BPY, CCTA, CBFA] Removal and Installation .

-- Remove battery holder -arrows-.

Fig 2: Identifying Battery Carrier Nuts

Courtesy of AUDI OF AMERICA, LLC

-- Unhook the front of the battery carrier from the air guide.

-- Pull out the relay carrier under engine compartment E-box -arrow-.

Fig 3: Locating Secondary Air Injection (Air) Pump Relay J299, New Version Of Relay Carrier

Courtesy of AUDI OF AMERICA, LLC

-- Remove the automatic glow time control module -1- from the relay carrier under the engine compartment E-box.

Installing

Install in reverse order of removal.

-- Install the battery. Refer to [For engine(s) CBRA, BPY, CCTA, CBFA] Removal and Installation .