VAC1 Shorted Wire Inspection

NOTICE: 

Before disconnecting the PCM connector, jump the SCS line with the HDS, and wait more than 1 minute.

Test Procedure 

• Preparation
• • -

    Brake booster pressure sensor connector (3P): disconnected

  • -

    PCM connector A (50P): disconnected

• Procedure
• • -

    Perform the inspection according to the following table.

    Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.

(Disconnected)Brake booster pressure sensor connector (3P)female terminals

IG Mode

Courtesy of HONDA, U.S.A., INC.

Normal Conditions

VAC1 shorted to ground inspection 

OFF

There is more than 1 MOhm 

Results 

• If abnormal, there is a problem in the circuit.