LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2014 >> TL Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> HANDSFREELINK System >> Control Unit Input Test >> Without Navigation
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Without Navigation

  1. Remove the HandsFreeLink Control Unit .
  2. Inspect the connector (A) and socket (B) terminals for a good pinfit to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals look OK, go to step 3.
    Fig 1: Identifying Connector And Socket Terminals
    G08071974Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Reconnect the connector, and make these input tests at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, go to step 4.
    Cavity Wire Color Test Condition Test: Desired Result Possible Cause if Desired Result is not Obtained
    1 BLK Ignition switch in ACCESSORY (I) or ON (II), or the engine start/stop button to ACC mode or ON mode Measure the voltage to body ground:
    There should be less than 0.2 V.
    • Poor ground (G501)
    • An open or high resistance in the wire
    15 WHT Under all conditions Measure the voltage to body ground:
    There should be battery voltage.
    • Blown No. 15 (10 A) fuse in the under-hood fuse/relay box
    • An open in the wire
    16 PUR Ignition switch in ACCESSORY (I) or ON (II), or the engine start/stop button to ACC mode or ON mode Measure the voltage to body ground:
    There should be battery voltage.
    • Blown No. 18 (7.5 A) fuse in the driver's under-dash fuse/relay box
    • An open in the wire
  4. Disconnect the 28P connector again, and make this input test at the connector.
    • If the test indicates a problem, find and correct the cause and check for B-CAN related DTCs, then recheck the system.
    • If the input test proves OK, the HandsFreeLink Control Unit is faulty, replace it.
Cavity Wire Color Test Condition Test: Desired Result Possible Cause if Desired Result is not Obtained
17 BLU Passenger's under-dash fuse/relay box connector D (28P) disconnected Check for continuity between terminal No. 17 and passenger's under-dash fuse/relay box connector D (28P) terminal No. 8:
There should be continuity.		 An open in the wire
18 PNK Passenger's under-dash fuse/relay box connector D (28P) disconnected Check for continuity between terminal No. 18 and passenger's under-dash fuse/relay box connector D(28P) terminal No. 7:
There should be continuity.		 An open in the wire
scientia non olet · About LEMON Manuals