Security Hood Switch Test

Open the hood then remove the bulkhead cover (see ENGINE COMPARTMENT COVER REPLACEMENT ).
Disconnect the 2P connector (A) from the security hood switch.

Fig 1: Identifying 2P Connector & Security Hood Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals.
- There should be continuity between terminals No. 1 and No. 2 when the hood is opened (latch released).
- There should be no continuity between terminals No. 1 and No. 2 when the hood is closed (latch pushed down).
If the continuity is not as specified, the switch is faulty; replace the hood latch (see HOOD LATCH REPLACEMENT ).