LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2005 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Navigation System) >> System Description >> Navigation Function >> Navigation Unit Inputs and Outputs for Connector C (8P)
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Navigation Unit Inputs and Outputs for Connector C (8P)

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Navigation Unit Connector C (8P) Terminals
G05488608Courtesy of AMERICAN HONDA MOTOR CO., INC.

Navigation Unit Connector C (8P) 

NAVIGATION UNIT CONNECTOR C (8P) TERMINAL REFERENCE

Terminal Number Wire Color Terminal Name Description Voltage (about) Symptom
1 WHT +B (+B Power source) Continuous power source Battery voltage If open: Display picture goes out (display back light still on).
NOTE: System will reboot to enter code screen. If short to ground: Blows fuse No. 5 (10 A) in the under-dash fuse/relay box.
2 PUR ACC (Accessory) Power source for accessories Battery voltage at ACC (1) If open: Display picture goes out (display back light still on).
If short to ground: Blows fuse No. 32 (10 A) in the under-dash fuse/relay box.
4 BLK GND (Ground) (G605) Ground for navigation unit 0 V If open: No effect on system.
If short to ground: No effect on system.
5 BRN BACK LT (Back light or reverse signal) Reverse signal of select lever from "Multiplex Integrated Control Unit" (A/T) or backup light switch (M/T) In reverse, battery voltage: Otherwise 0 V If open: Navigation never sees reverse. Diagnostic screen Car Status, Back=0.
If short to ground: Blows fuse No. 21 (7.5 A) in the driver's under-dash fuse/relay box.
6 BLU VSP (Vehicle speed pulse) Vehicle speed pulse signal from PCM 0-5 V pulses 2.5 V average (depends on Bus traffic) If open: No vehicle speed pulses.
Diagnostic screen Car Status, VSP Navi=0.
If short to ground: No vehicle speed pulses.
Diagnostic screen Car Status, VSP Navi=0.
7 GRY DIAG+ (Diagnostic positive) Service check signal for navigation system 5-6 V If open: No effect on system.
If short to ground: System goes into diagnostic mode at key ON (I) and (II).
8 YEL DIAG--(Diagnostic negative) Ground for service check signal 0 V If open: The system will not go into diagnostic mode when using the SCS jumper.
If short to ground: No effect on system.