LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2000 >> NSX-T 3.2 NA2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Shift Interlock Systems) >> Removal & Installation >> Gear Position Switch
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Gear Position Switch

WARNING: This page is about a different variant/trim than selected.
  1. Remove the console, then disconnect the 12-pin and 2-pin connectors from the A/T gear position switch.
  2. Remove the two position switch mounting bolts.
  3. Position the slider on the new switch to Neutral. See .Fig 1
  4. Shift the shift lever to Neutral, then slip the switch into position.
  5. Attach the switch with the two bolts.
  6. Test the switch in the Park and Neutral positions. You should be able to start the engine with the shift lever in Neutral position anywhere in the range of free play. Adjust switch if necessary. See GEAR POSITION SWITCH  under ADJUSTMENTS.
  7. Connect the 12-pin and 2-pin connectors, clamp the harness, and install the console.
Fig 1: Removing Gear Position Switch
G00118574Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals