LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1997 >> 2.2CL Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Controls - Adjustments >> Adjustment >> Ignition Timing >> Checking Ignition Timing
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Checking Ignition Timing

  1. Start engine and run at 3000 RPM with no loads and transmission in Park or Neutral, until radiator fan comes on. Allow engine to idle. Locate 2-pin service check connector (behind right kick panel). Install Service Check Connector Tool (07PAZ-0010100 ), into service check connector. See Fig 1 .
  2. Connect inductive timing light to No. 1 spark plug wire. Ensure idle speed is within specification. See IDLE SPEED  under IDLE SPEED & MIXTURE. Red (16° BTDC) mark on crankshaft pulley should align with pointer on timing belt cover.
  3. If Red mark and pointer are not aligned, adjust base ignition timing by turning distributor. Rotate distributor counterclockwise to advance timing and clockwise to retard timing. See IGNITION TIMING  . Tighten distributor mounting bolts to 16 ft. lbs. (22 N.m) Remove service check connector tool from service check connector.
    Fig 1: Installing Service Check Connector Tool
    G96C01345Courtesy of AMERICAN HONDA MOTOR CO., INC.
    IGNITION TIMING (1) (Degrees BTDC - RED MARK @ RPM)

    Application (2) Man. Trans. (3) Auto. Trans.
    2.2CL 13-17 @ 700-800 13-17 @ 700-800
    (1) Install Service Check Connector Tool (07PAZ-0010100 ) to service check connector before checking timing.
    (2) Manual transmission in "N".
    (3) Automatic transmission in "N" or "P".
scientia non olet · About LEMON Manuals