LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1995 >> Integra GS-R, 4D Sedan >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Compressor Refrigerant Oil Checking >> Compressor Oil Checking >> NIPPONDENSO - 10-Cylinder
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

NIPPONDENSO - 10-Cylinder

A new compressor is shipped with refrigerant oil. Drain and measure oil from old compressor. Remove refrigerant oil from new compressor equal to difference between amount drained from old compressor and amount shipped in new compressor. If new compressor is shipped without refrigerant oil, add same amount of oil that was drained from old compressor. If any other major components are replaced, add refrigerant oil as specified. See COMPONENT REFRIGERANT OIL CAPACITIES  table.

COMPONENT REFRIGERANT OIL CAPACITIES

Component Ounces
Compressor (1)
2.5TL 5.3
3.2TL 4.3
Condenser
Accord 0.8
2.5TL & 3.2TL 0.8
Integra 0.8
Legend 1.0
Evaporator
2.5TL & 3.2TL 1.7
Integra 1.3
Legend 2.0
Receiver-Drier
2.5TL & 3.2TL 0.5
Integra 0.3
Legend 0.3
Refrigerant Lines
2.5TL & 3.2TL 0.7
Integra 0.3
Legend 0.3
(1) If new compressor is shipped without oil, add same amount of new oil to new compressor that was drained from old compressor. DO NOT  subtract more than 1.7 oz. of refrigerant oil from new compressor. After adding oil to compressor, rotate compressor 10 times before operating system to prevent compressor damage.
scientia non olet · About LEMON Manuals