Ignition Timing

Operate engine until cooling fan comes on. Locate Brown/White and Black 2-pin connector under right kick panel. Using Short Connector (07PAZ-010100 ), connect terminals of ignition timing adjuster connector together. See Fig 1 .

Red mark on crankshaft pulley should align with pointer. See Fig 2 . If Red mark and pointer are not aligned, adjust base ignition timing by turning distributor. See IGNITION TIMING table. Remove short connector from ignition timing adjusting connector.

Fig 1: Locating Ignition Timing Adjusting Connector

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Locating Ignition Timing Marks

Courtesy of AMERICAN HONDA MOTOR CO., INC.

IGNITION TIMING (Degrees BTDC @ RPM)

Application

⁽¹⁾ M/T

⁽²⁾ A/T

Integra

14-18 @ 700-800

⁽¹⁾	Manual transmission in Neutral.

⁽²⁾	Automatic transmission in Neutral or Park.