Leak Detection Pump: Service and Repair

Leak Detection Pump V144

Removing

- Disconnect the vacuum line - 1 -, ventilation line - 2 - and ventilation line - 3 -.






- Remove the nuts - arrows -.

- Remove the leak detection pump with the bracket and disconnect the electrical connector.

Installing

Install in the reverse order of removal. Note the following:

• Before installing the pump with the bracket, connect the electrical connector.

• The vent line - 2 - must engage audibly.

Tightening Specifications

- For the tightening specifications, refer to => [ EVAP System Overview ] EVAP System Overview.