Leak Detection Pump: Service and Repair

Leak Detection Pump

Removing

- Remove the right rear wheel housing liner..

- Disconnect the vacuum line - 1 -.






- Disconnect the electrical connector - 2 -.

- Disconnect the vent line - 3 - by pressing the release button.

- Remove the nuts - arrows -.

- Disengage the leak detection pump with bracket.

Installing

Install in reverse order of removal. Note the following:

• The vent line - 3 - must engage audibly.

- Install the right rear wheel housing liner..

Tightening specifications, refer to => [ EVAP System Component Overview ] EVAP System Component Overview.