Diagnostic Mode 7: Check Test Results of Components That Are Continuously Monitored

Diagnostic Mode 07 displays all stored DTCs of emission related components and systems which are continuously monitored.

Note:
- Depending on scan tool and protocol used, diagnostic mode 07 and the information provided may be referred to by a different name.

Test requirements
- No DTCs stored in the DTC memory.
- Coolant temperature at least 80�C.

Procedure
- Connect the scan tool.
- Start the engine and run at idle.

Note:
- If the engine does not start, crank the engine using starter for at least 5 seconds, do not switch the ignition off afterward under any circumstances.

- Select "Mode 7: Check test results of components that are continuously monitored".

The number of stored DTCs or "0 malfunctions detected" will be displayed scan tool screen.

- Switch the ignition off.
- Refer to the following DTC tables for the diagnostic repair procedure:
- SAE P0xxxDTCs. P Code Charts
- SAE P1xxxDTCs. P Code Charts
- SAE P2xxxDTCs. P Code Charts

- Switch the ignition off.
- End of diagnosis.