Wiper Motor Removal and Installation

Wiper Motor Removal and Installation

Removal

1) Remove pivot caps (1) and wiper arm nuts (2), and remove wiper arms (3).
2) Remove cowl top garnish (4).





3) Disconnect wiper motor connector (3).
4) Remove wiper motor bolts (1) and remove wiper motor (2).






Installation

Reverse removal procedure noting the following points.

- Tighten wiper motor bolts in numerical order ("1" through "3") to specified torque.

Tightening torque
Wiper motor bolt (a): 8.3 Nm (0.85 kgf-m, 6.5 lbf-ft)





- Install wiper arms (1) in positions shown in figure and tighten wiper arm nuts to specified torque.

Tightening torque
Wiper arm nut (a): 20 Nm (2.0 kgf-m, 15.0 lbf-ft)