DTC Clearance

DTC Clearance

1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to DLC (1) located on underside of instrument panel.
Special Tool

(A): SUZUKI scan tool (SUZUKI-SDT)





3) Turn ignition switch to ON position.
4) Erase DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operator's manual for further details.
5) After completing clearance, turn ignition switch OFF and disconnect SUZUKI scan tool from DLC.

NOTE:
DTC stored in 4WD control module memory are also cleared in the following cases. Be careful not to clear them before keeping their record.
- When power to 4WD control module is cut off (by disconnecting battery cable, removing fuse or disconnecting 4WD control module connectors).
- When the same malfunction (DTC) is not detected again during 40 engine warm-up cycles.