P0713

DTC P0713

DTC Detecting Condition and Trouble Area





Wiring Diagram
Refer to DTC P0711. P0711

DTC Confirmation Procedure

WARNING:
^ When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
^ Road test should be carried out with 2 persons, a driver and a tester, on a level road.

NOTE:
^ If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
^ Check that the following conditions are satisfied when using this procedure.
- Battery voltage > 10.5 V

1) Warm up engine to normal operating temperature.
2) Drive vehicle more than 20 km/h (12 mile/h) for 20 sec.

DTC Troubleshooting

Step 1-3: