P0575

DTC P0575: Cruise Control Input Circuit

Wiring Diagram

Wiring Diagram:

DTC Detecting Condition and Trouble Area






DTC Confirmation Procedure

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out by 2 persons, a driver and a tester, on a level road.

NOTE: If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.

1. With ignition switch turned OFF, connect scan tool to DLC.
2. Turn ON ignition switch and clear DTC.
3. Start engine and warm up to normal operating temperature.
4. Press cruise MAIN (ON/OFF) switch once.
5. Drive vehicle at 40 km/h (25 mph) or higher for 3 min. or more.
6. Stop vehicle.
7. Check DTC.

DTC Troubleshooting

NOTE: Before this troubleshooting, read and observe Precautions for DTC Troubleshooting.

Step 1-2: