P0500

DTC P0500

DTC Detecting Condition and Trouble Area

Wiring Diagram

Wiring Diagram:

DTC Confirmation Procedure

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out by 2 persons, a driver and a tester, on a level road.

NOTE: If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.

1. Warm up engine to normal operating temperature.
2. Drive vehicle at 100 km/h (62 mile/h) for 1 min. (Keep throttle valve opening constantly in this step.
3. Release accelerator pedal, and keep vehicle coasting for 10 sec. with engine braking applied. (fuel cut condition)

DTC Troubleshooting

Step 1-3: