DTC Clearance

DTC Clearance

WARNING:
When performing driving test, select safe place where there is neither traffic jam nor any traffic accident possibility and take care not to occur an accident.

1) Confirm that ignition mode of keyless push start system is in "OFF".
2) Connect SUZUKI scan tool connector to DLC.
3) Push engine switch to change the ignition mode of keyless push start system to "ON".
4) Erase DTC according to instructions displayed on scan tool. Refer to scan tool operator's manual for further details.
5) Perform "Step 3: Driving Test" in ESP(R) System Check and DTC Check and confirm that NO DTC is displayed on scan tool. ESP(R) System Check DTC Check
6) Disconnect SUZUKI scan tool connector from DLC after completing the DTC clearance.