P1839

DTC P1839 EDS 3 Output Shorted to Ground






Circuit Description
The pressure control valves (EDS valves 3, 4, 5 and 6) are precision electronic pressure regulators that control the operation of the clutches, brakes and lock-up clutch. The valve reduces the system pressure with which the downstream solenoid valves and electrical pressure regulating valves are supplied. It is possible to use smaller solenoid valves as a result. The EDS require a constant input pressure.

Conditions for Setting the DTC
^ Output voltage of the EDS 3 is less than 2 volts.
^ No DTC P1840, P1841.
^ Immediately after the above condition occurs.

Action Taken When the DTC Sets
^ The Malfunction Indicator Lamp (MIL) will illuminate.
^ The TCM will record operating conditions at the time the diagnostic fails. This information will be stored in the Failure Records buffer.
^ Adopt Emergency/ Substitute mode and constant 4th gear by hydraulic control.
^ After ignition OFF/ON: 3rd gear by hydraulic control. Possible P, R and N also possible.
^ Power supply cut off to the EDS valve.

Conditions for Clearing the MIL/DTC
^ The MIL will turn OFF when the malfunction has not occurred after three-ignition cycle.
^ A history DTC will clear after 40 consecutive warm up cycles without a fault.
^ Using a scan tool can clear history DTCs.

Diagnostic Aids
^ When DTC P1839 sets, the possible cause of fault could be EDS3 valve.

Steps 1-10:

DTC P1839 - EDS 3 Output Shorted to Ground