P0106

Wiring Diagram:

CIRCUIT DESCRIPTION
Refer to MAP Sensor Operation.

Detecting Condition / Possible Cause:

NOTE:
- It is possible that filter in MAP sensor is clogged by freezing. If it is suspected, leave it at room temperature (20 °C, 68 °F) for a while and proceed to the following inspection.
- Note that barometric pressure varies depending on weather conditions as well as altitude. Take that into consideration when inspecting.

DTC CONFIRMATION PROCEDURE
1. Turn ignition switch OFF Clear DTC with ignition switch ON, check vehicle and environmental condition for:
- Indication of fuel level meter in combination meter: 1/4 or more
- Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
- Ambient temp.: -10 °C, 14 °F or higher
- Intake air temp.: 70 °C, 158 °F or lower
- Engine coolant temp.: 70 - 110 °C, 158 - 230 °F

2. Start engine and keep it at idle for 2 min.
3. Increase engine speed to 4000 r/min and release accelerator pedal so that engine is in fuel cut condition.
4. Check DTC in "DTC" mode and pending DTC in "ON BOARD TEST" or "PENDING DTC" mode.

Inspection (Steps 1 - 4):