Input/Turbine Speed Sensor Inspection

INPUT/TURBINE SPEED SENSOR INSPECTION [FN4A-EL]

Caution: Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign material on the connector when disconnecting it.

1. Remove the battery duct and battery cover.
2. Remove the battery, battery box and battery tray.





3. Disconnect the input/turbine speed sensor connector.





4. Measure the resistance between the input/turbine speed sensor terminals. If there is any malfunction, replace the input/turbine speed sensor.

Resistance 250 - 600 ohms (ATF temperature: -40-160° C (-40 - 320° F))

5. Connect the input/turbine speed sensor connector.
6. Install the battery, battery box and battery tray
7. Install the battery duct and battery cover.